
6.3 Cartridge emulation menu
“
FlashWrite
” is in the right position (
ON
). The cartridge emulation is completely disabled
if both switches are in the left position (OFF).
6.3 Cartridge emulation menu
The current configuration is displayed in the middle of the screen. The online help with
the available options is displayed at the bottom of the screen.
MODE Selects the emulated module type.
OFF deactivates the cartridge emulation.
PicoDos starts the integrated MyPicoDos instead of a module.
SRC Selects the flash ROM or freezer RAM as source for the module data.
BANK Selects the flash ROM or freezer RAM start bank.
SDX
Selects the SpartaDOS X emulation. You can choose between
OFF
,
ROM Bank 0, ROM Bank 64 and RAM Bank 0.
BOOT
Selects if the module shall be started via a cold start (
COLD
) or a warm
start (
WARM
). This option should normally be set to
COLD
, because other-
wise the operating system variables and the module are not correctly initial-
ized. The option
WARM
is intended for developers and only makes sense if
the cartridge emulation was activated from the
TURBO FREEZER
menu via
[Shift]
+
[K]
. This way the cartridge emulation can be reconfigured while
keeping the internal RAM of the ATARI unchanged. This can be useful during
development.
Some frequently used configurations can be selected with a single key press.
[D]
Selects the default configuration:
Mode 8k
,
Bank 0
,
Source ROM
,
SDX OFF
and
Boot Cold.
[P] Selects the Mode PicoDos.
[O] Deactivates the cartridge emulation: Mode OFF, SDX OFF
Pressing the
[RETURN]
key activates the currently selected configuration. Pressing
[ESC]
deactivates the cartridge emulation and restarts the Atari.
6.4 Command summary
The debugger supports the following commands, which all begin with
K
, to control
the cartridge emulation. The commands have the same effect as manually chaning the
configuration registers starting at $D500, but some people are said to prefer mnemonics
over manual entry of hexadecimal values.
43
Komentáře k této Příručce